General Discussion

Getting Started Every community like ours gets a lot of new users with questions. This is the prefect place for that.

Welcome to the Macchina Development Forum (READ ME) [General Discussion] (5)
About the General Discussion category [General Discussion] (1)
CANBUS Tachometer, A Little Help? [General Discussion] (1)
2017 GM HMI Calibration / VIN setting ( 2 3 4 ) [General Discussion] (65)
Problemes and Features for an IOT project [General Discussion] (4)
Incoming CAN data seems extremely slow, the M2 is getting hung up somewhere, but I can't find where [General Discussion] (6)
SavvyCAN sending requests [Getting Started] (5)
M2 based commercial software companies? [General Discussion] (2)
ERROR! Issues Sending SWCAN Frames with M2 Example [General Discussion] (8)
EV Battery Management System [General Discussion] (1)
Sending and Receiving Responses [General Discussion] (2)
BMW Motorrad LIN BUS controlling turn signal [General Discussion] (17)
Any programmers for hire? [General Discussion] (6)
The Car Hacker's Handbook for 1$ [General Discussion] (12)
Because it does not work two macchina per can [General Discussion] (4)
Shift Light Project [General Discussion] (5)
Wanted: SavvyCAN HowTo ( 2 3 ) [General Discussion] (51)
Producing K-line initialization sequence [General Discussion] (9)
2008 GM alarm status over CAN? [General Discussion] (3)
Real-time MPG display on an older car [Blog] (5)
K-line serial printing does not show anything on an oscilloscope [General Discussion] (11)
Waking up the bus so I can send OBD2 queries on GM [General Discussion] (3)
Matlab Support Package for Arduino [General Discussion] (1)
Logging CAN BUS information - getting started with an M2 & M2RET [Getting Started] (6)
Writing to GMLan (SWCAN) [Getting Started] (5)
J1850-VPW schematic question ( 2 ) [General Discussion] (25)
Support for j1850 VPW/PWM? ( 2 3 4 5 6 ) [General Discussion] (116)
M2 with C and atmel studio? [General Discussion] (3)
M2 UTD not receiving any data from vehicle [General Discussion] (3)
Looking to give some talks on car hacking Wanting some advice [General Discussion] (4)