Where can I find the pin out for the UTH version?
Thought it was in the guide but I don’t see it now. I also bought a new “simulator” module as described elsewhere and plan to hard wire these two together.
Thanks!
Pinout can be found on page 2 of the schematic here:
https://github.com/macchina/m2-hardware/blob/master/M2/Interface%20Board%20Schematic.pdf
and here is a diagram and table to make it easier to identify pins on actual connector:
http://docs.macchina.cc/m2/technical-references/installation.html
Ok thanks! The second one was not there yesterday so I am guessing you added this today.
I figured was likely in the schematics for what each pin was but wasn’t sure of configuration of the actual plug. The documentation in the guide makes it very clear.
One note about the docs… Can you make them printable?
It is hard to print off a copy of these to insure you are pinning them correctly.
I had to add an extension to firefox to be able to convert the page to a picture which I could save to disk or print out.
Much easier to hook up if you can print the documentation.
Thank you!
Some CSS for printing can be looked into. I thought GitBook had that OOTB, so some investigation will be needed.
In the meantime, if you are willing to build it yourself, the toolchain can generate a PDF or eBook.
I was able to use an add on but it is not intuitive currently to print off documentation.