I just tried to run the SavvyCAN with my system that I had on my system for past month or so that works fine in vehicle.
With my test lab I have not been able to get it to work. I will try again in vehicle over the weekend to insure it still works in vehicle but what I am getting is that it will connect to the M2 and tell me there are 2 ports available but doesn’t show it is connected. I activate the port I want and nothing happens. I have constant data stream running. The two simulators I have are talking to each other every second or so. If I connect my STN device it works perfectly.
I have compiled the software and gone to the serial monitor hoping to see something but I get giberish that looks like wrong baud rate. I try every baud rate for the monitor and still same jiberish. One other thing I haven’t tried is I have a 120 ohm resistor across the canbus ports. My STN adapter won’t connect without it. Not sure if this is normal or not?