I used my included connector and wires to wire obd2 ports. Now I want to wire it directly to the canbus.
Where can I get more 24 and 26 pin connectors?
Yes I to was wondering about this. I was also wondering about just getting more wires and a tool to remove them from the connectors.
You can use a small flat head jewlers screwdriver to remove the wires. There is a small plastic tab that holds the pins in place and to remove then you GENTLY pull the plastic tab with a screwdriver while pushing in the pin to take pressure off the tab. Once you have the tab out just far enough to clear the tab you can just tug the wire and it pulls out.
Thanks for the feedback here! We’ll post up a link to order wires ASAP.
And yes, @redheadedrod is absolutely correct, no need for a special tool with these connectors. Follow his instructions to remove a wire from the plastic housing.
Hi, did you find where to order them, I just lost mine lol.
I am not sure if it is an universal connector, but it would be nice if I can just get the model name and order them from a local store.
Hi I followed redheadedrod’s instructions on pin removal and it works well. I am still running low on wires as I have a lot of things to control. Any news on the order link?
Hey all, we just added this product to the store. Here is the page for the 24-pin connector and wires:
https://www.macchina.cc/content/24-pin-connector-and-wires
and here is the link for the 26-pin connector and wires: